Author Topic: Tilt trim NMEA 2000  (Read 120 times)

admin

  • Administrator
  • Newbie
  • *****
  • Posts: 18
Tilt trim NMEA 2000
« on: May 13, 2018, 06:51:50 PM »
If you are trying to read your engines tilt and trim level via a NMEA 2K device then you must have the following.

1- EVDIAGS software to calibrate the range of the sensor.
2- a 47 ohn 5w(Minimum) resistor connected from the purple wire to the Wht/Tan wire on the analog gauge.

The analog gauge should be removed.

WARNING, do not apply 12V direct to the Wht/Tan wire this may damage the ECU.